e-ISSN 2231-8526
ISSN 0128-7680
Muhammad Hakirin Roslan, Norhafiz Azis, Mohd Zainal Abidin Ab Kadir, Jasronita Jasni and Mohd Fairouz Mohd Yousof
Pertanika Journal of Science & Technology, Volume 31, Issue 6, October 2023
DOI: https://doi.org/10.47836/pjst.31.6.15
Keywords: Insulation paper, partial discharge modeling, spherical cavity, transformer
Published on: 12 October 2023
This paper examines the influence of cavity size and location in the insulation paper on the Partial Discharge (PD) activities through Finite Element Method (FEM). The model consisted of a conductor wrapped with insulation paper. Two different locations of the spherical cavities were introduced in this study, namely Location 1 (L1) and Location 2 (L2), located at the center and left corner of the insulation paper. The model introduced two different sizes of cavities with diameters of 0.5 mm and 0.8 mm. An AC voltage source of 17 kV, 50 Hz, was applied at the conductor while the bottom of the insulation paper was grounded. The real and apparent PDs were obtained by integrating the current flowing through the cavity and ground electrode with the respective surface area. The simulation was carried out for 100 cycles. The resultant model was used to study the PD occurrence, magnitude, and Phase Resolved Partial Discharge (PRPD) within the insulation paper. It is found that the large cavity size produces a lower number of PD occurrences per cycle than the small cavity size. The large cavity size produces a higher charge magnitude as compared with the small cavity size. The PD occurrence per cycle and charge magnitude are higher for the cavity location at L1 compared to L2. The PRPD yields the same pattern for cavity location at L1 and L2, whereby the differences are only on the charge magnitude and PD occurrence per cycle.
Afrouzi, H. N., Hassan, A., Chee, D. T. Y., Mehranzamir, K., Malek, Z. A., Mashak, S. V., & Ahmed, J. (2022). In-depth exploration of partial discharge modelling methods within insulations. Cleaner Engineering and Technology, 6, Article 100390. https://doi.org/10.1016/j.clet.2021.100390
Borghei, M., & Ghassemi, M. (2019). Partial discharge analysis under high-frequency, fast-rise square wave voltages in silicone gel: A modeling approach. Energies, 12(23), Article 4543. https://doi.org/10.3390/en12234543
Borghei, M., & Ghassemi, M. (2020). A finite element analysis model for partial discharges in silicone gel under a high slew rate, high-frequency square wave voltage in low-pressure conditions. Energies, 13(9), Article 2152. https://doi.org/10.3390/en13092152
Borghei, M., & Ghassemi, M. (2021). Characterization of partial discharge activities in WBG power converters under low-pressure condition. Energies, 14(17), Article 5394. https://doi.org/10.3390/en14175394
Borghei, M., Ghassemi, M., Rodriguez-Serna, J. M., & Albarracin-Sanchez, R. (2021). A finite element analysis and an improved induced charge concept for partial discharge modeling. IEEE Transactions on Power Delivery, 36(4), 2570-2581. https://doi.org/10.1109/tpwrd.2020.2991589
Borghei, S. M. R. (2022). Partial discharges: Experimental investigation, model development, and data analytics [Doctoral dissertation]. Virgina Polytechnic Institue, USA. http://hdl.handle.net/10919/108321
Callender, G., & Lewin, P. L. (2020). Modeling Partial Discharge Phenomena. IEEE Electrical Insulation Magazine, 36(2), 29-36.
CIGRE. (2017). Partial discharges in transformers (Working Group D1.29). CIGRE. https://www.slideshare.net/PowerSystemOperation/partial-discharges-in-transformers
Forssén, C. (2008). Modelling of cavity partial discharges at variable applied frequency [Doctoral dissertation]. KTH, Sweden. https://www.diva-portal.org/smash/record.jsf?pid=diva2%3A13791&dswid=6945
Forssén, C., & Edin, H. (2008). Partial discharges in a cavity at variable applied frequency Part 2: Measurements and modeling. IEEE Transactions on Dielectrics and Electrical Insulation, 15(6), 1610-1616. https://doi.org/10.1109/TDEI.2008.4712664
Hussain, M. R., Refaat, S. S., & Abu-Rub, H. (2021). Overview and partial discharge analysis of power transformers: A literature review. IEEE Access, 9, 64587-64605. https://doi.org/10.1109/access.2021.3075288
IEC60270. (2000). High-voltage test techniques - Partial discharge measurements. British Standard. http://teslapishro.ir/wp-content/uploads/2019/12/High-voltage-test-technique.pdf
Illias, H. A. (2011). Measurement and simulation of partial discharges within a spherical cavity in a solid dielectric material [Doctoral dissertation] University of Southampton, UK. https://eprints.soton.ac.uk/194921/1/HazleeThesis_EPRINTS.pdf
Illias, H. A., Chen, G., & Lewin, P. L. (2011). Partial discharge behavior within a spherical cavity in a solid dielectric material as a function of frequency and amplitude of the applied voltage. IEEE Transactions on Dielectrics and Electrical Insulation, 18(2), 432-443. https://doi.org/10.1109/tdei.2011.5739447
Illias, H. A., Chen, G., & Lewin, P. L. (2012). Partial discharge within a spherical cavity in a dielectric material as a function of cavity size and material temperature. IET Science, Measurement & Technology, 6(2), 52-62. https://doi.org/10.1049/iet-smt.2011.0091
Illias, H. A., Chen, G., & Lewin, P. L. (2017). Comparison between three-capacitance, analytical-based and finite element analysis partial discharge models in condition monitoring. IEEE Transactions on Dielectrics and Electrical Insulation, 24(1), 99-109. https://doi.org/10.1109/tdei.2016.005971
Illias, H. A., Tunio, M. A., Bakar, A. H. A., Mokhlis, H., & Chen, G. (2016). Partial discharge phenomena within an artificial void in cable insulation geometry: Experimental validation and simulation. IEEE Transactions on Dielectrics and Electrical Insulation, 23(1), 451-459. https://doi.org/10.1109/tdei.2015.005155
Joseph, J., Mohan, S., & Thiruthi Krishnan, S. (2019). Numerical modelling, simulation and experimental validation of partial discharge in cross‐linked polyethylene cables. IET Science, Measurement & Technology, 13(2), 309-317. https://doi.org/10.1049/iet-smt.2018.5248
Meitei, S. N., Borah, K., & Chatterjee, S. (2021). Partial discharge detection in an oil-filled power transformer using fiber bragg grating sensors: A review. IEEE Sensors Journal, 21(9), 10304-10316. https://doi.org/10.1109/jsen.2021.3059931
Morsalin, S., & Das, N. (2020). Diagnostic aspects of partial discharge measurement at very low frequency: A review. IET Science, Measurement & Technology, 14(10), 825-841. https://doi.org/10.1049/iet-smt.2020.0225
Murthy, A. S., Azis, N., Jasni, J., Othman, M. L., Mohd Yousof, M. F., & Talib, M. A. (2020). Extraction of winding parameters for 33/11 kV, 30 MVA transformer based on finite element method for frequency response modelling. PLoS One, 15(8), Article e0236409. https://doi.org/10.1371/journal.pone.0236409
Naidu, M. S., & Kamaraju, V. (2013). High Voltage Engineering. McGraw Hill.
Pan, C., Chen, G., Tang, J., & Wu, K. (2019). Numerical modeling of partial discharges in a solid dielectric-bounded cavity: A review. IEEE Transactions on Dielectrics and Electrical Insulation, 26(3), 981-1000. https://doi.org/10.1109/tdei.2019.007945
Pedersen, A., Crichton, G. C., & McAIIister, I. W. (1995). The functional relation between partial discharges and induced charge. IEEE Transactions on Dielectrics and Electrical Insulation, 2(4), 535-543. https://doi.org/10.1109/94.407019
Pedersen, A., Crichton, G. C., & McAlIister, I. W. (1991). The theory and measurement of partial discharge transients. IEEE Transactions on Electrical Insulation, 26(3), 487-497. https://doi.org/10.1109/14.85121
Saha, T. K., & Purkait, P. (2008). Understanding the impacts of moisture and thermal ageing on transformer’s insulation by dielectric response and molecular weight measurements. IEEE Transactions on Dielectrics and Electrical Insulation, 15(2), 568-582. https://doi.org/10.1109/TDEI.2008.4483479
Sikorski, W., Walczak, K., Gil, W., & Szymczak, C. (2020). On-line partial discharge monitoring system for power transformers based on the simultaneous detection of high frequency, ultra-high frequency, and acoustic emission signals. Energies, 13(12), Article 3271. https://doi.org/10.3390/en13123271
Whitehead, S. (1952). Electrical breakdown of solids. Nature, 170(4319), Article 219. https://doi.org/10.1038/170219a0
Xavier, G. V. R., Silva, H. S., da Costa, E. G., Serres, A. J. R., Carvalho, N. B., & Oliveira, A. S. R. (2021). Detection, classification and location of sources of partial discharges using the radiometric method: Trends, challenges and open issues. IEEE Access, 9, Article 110787-110810. https://doi.org/10.1109/access.2021.3102888
Xiao, L., Ruijin, L., Maochang, L., Lijun, Y., Junkun, Y., & Chaoliang, Q. (2013, October 20-23). Influence of aging degree on polarization and depolarization currents of oil-paper insulation [Paper presentation]. Annual Report Conference on Electrical Insulation and Dielectric Phenomena, Chenzhen, China. https://doi.org/10.1109/CEIDP.2013.6748255
Youssef, M. ., Ibrahim, R. A., Desouki, H., & Moustafa, M. M. Z. (2022, March 4-6). An Overview on Condition Monitoring & Health Assessment Techniques for Distribution Transformers [Paper presentation]. 6th International Conference on Green Energy and Applications (ICGEA), Singapore. https://doi.org/10.1109/ICGEA54406.2022.9791900
ISSN 0128-7680
e-ISSN 2231-8526